Starter Motor Reassembly - Suzuki GW250 Service Manual

ARMATURE COIL
Inspect for continuity between each segment and between each
segment and the armature shaft using the multi circuit tester.
If there is no continuity between the segments or there is conti-
nuity between the segments and shaft, replace the armature
with a new one.
 09900-25008: Multi circuit tester set
 Tester knob indication: Continuity test ()
OIL SEAL AND BEARING
Inspect the oil seal lip for damage or leakage.
Inspect the bearing for abnormal noise and smooth movement.
If any defects are found, replace the housing end (inside).
BUSHING
Inspect the bushing for wear and damage.
If any defects are found, replace the housing end (outside).

STARTER MOTOR REASSEMBLY

Reassemble the starter motor in the reverse order of disassem-
bly. Pay attention to the following points:
• Apply grease to the lip of the oil seal and bearing.
 99000-25010: SUZUKI SUPER GREASE "A"
• Apply a small quantity of moly paste to the armature shaft.
 99000-25140: SUZUKI MOLY PASTE or equivalent
or equivalent
ELECTRICAL SYSTEM 9-15
