T1 Gateway Indicators - AT&T SB67010 PSTN Installation Manual

Synapse Installation Guide

T1 Gateway Indicators

I cannot make or receive phone calls and the T1 Gateway SYN/ACT LED is GREEN.
Probable Cause
There are no T1 channels
available to make the call.
I cannot make or receive phone calls and the T1 Gateway RAI/LOF/LOS LED is YELLOW.
Probable Cause
The Yellow Alarm is a
Remote Alarm Indication.
Telephone equipment outside
of your Synapse system is
sending an alarm that signals
that it is receiving unreliable
signals.
I cannot make or receive phone calls and the T1 Gateway RAI/LOF/LOS LED is RED.
Probable Cause
The Red Alarm indicates Loss
of Frame. A signal is present,
but its pattern cannot be
interpreted.
There is an error in the signal
from the service provider.
Troubleshooting
Corrective Action
Check the T1 trunk configuration.

a. Log on to the WebUI as administrator, click
System Settings, then T1 Settings.
b. Verify that Number of Voice Channels and
Lowest Voice Channel have been
configured correctly according to your T1
service.
Click Trunk Reservation and verify that the
c.
assignments are correct.
Corrective Action
1. Check the T1 Settings to confirm that the
configuration parameters (Signaling type,
Buildout) correspond to the service provider's.
2. If the problem remains, contact your T1 service
provider.
Corrective Action
1. Check the T1 Settings to confirm that the
configuration parameters (Signaling type, Build
out) correspond to the service provider's.
2. If the problem remains, contact your T1 service
provider.
108
Back to Contents