Ata Features - AT&T SB67010 PSTN Installation Manual

Synapse Installation Guide

ATA Features

When an ATA is first connected to your LAN, the two FXS ports are configured as POTS
phone lines and assigned the next available extension numbers. ATA extension numbers
do not appear in the Extension list on Deskset screens. They do, however, appear on Call
Logs, Redial lists, and Message lists. The ATA extensions do not count toward the
100-extension limit of the Synapse system.
In addition, one 10/100BT Ethernet port (labeled LAN) is provided for communication
with the Synapse network. The front panel LCD and buttons allow network configuration,
firmware upgrades, and information functions. Figure 37 illustrates the ATA features and
connections.
1. Display
2. Reset
3. FXS 1, FXS 2
4. AUX IN
5. AUX OUT
6. RJ-45 Ethernet Network Port
7. DC 12V Power-Supply Jack
Getting Started
1
2
Figure 37. ATA Features and Connections
Provides system and network status, device information, and
configuration data. See
Restarts the ATA when pressed momentarily. Restores factory
defaults when pressed and held for more than five seconds with
the LAN cable not connected.
Station ports for analog telephones, a fax machine, door phone, or
overhead paging equipment.
Audio in for Music on Hold.
Audio out, an option for overhead paging.
10Base-T/100Base-Tx with Auto MDI/MDI-X switching.
3 4 5
"ATA Front Panel Interface" on page
66
Back to Contents
6 7
68.