Synapse Installation Guide
Connecting a Music on Hold Source
On-hold music functionality should only be used in conjunction with music
specifically licensed for on-hold use. Licensed on-hold music is available from
many third-party suppliers. AT&T disclaims any liability arising from the failure to
obtain such a license.
To install a music on hold source:
1. Use the supplied auxiliary audio cable to plug a streaming audio source, such as a
radio or MP3 music player, into the ATA AUX IN port as shown in Figure 27. If the
supplied cable does not connect to your music source, use another cable that will
connect your device to the 3.5 mm AUX IN port. This audio source must have a
volume control. The volume adjustment on the audio device should be set to obtain
the preferred level of music on hold within the system.
2. Enable Music on Hold under Hold/Park Settings in the WebUI.
Installation
The ATA AUX IN port is set up to receive headphone-out audio signals. Do
not connect to a "Line-Out" audio source or to speaker outputs.
For more information, see "Configuring Hold/Park Settings and Music on Hold"
in the Synapse Administrator's Guide at
www.telephones.att.com/synapseguides
ATA
Figure 27. ATA Music on Hold Source Installation
47
Back to Contents
.
Music on Hold
Source