Ata Configuration; Upgrade Ata Software - AT&T SB67010 PSTN Installation Manual

Synapse Installation Guide

ATA Configuration

Press
shown in Figure 41, and press
setting is indicated with [*]. You can use this interface or the WebUI to upgrade
software.
Configuration — Current ATA settings:
Auto IP — Is set automatically.

Static IP — You can change the Static IP only from the ATA. See your network

administrator if you require details regarding IP assignments.
Restore Defaults — Highlight Restore Defaults and press and hold

two seconds when prompted to restore the ATA to factory defaults.
Upgrade Software — Highlight Upgrade Software, and press

software is available, you are prompted to press
upgrade.

Upgrade ATA Software

You can also upgrade ATA software using the WebUI. See
page 89.
If you have system settings that you want to retain, back up the settings before
upgrading the system software. For information on how to back up an ATA, see
"Reconnecting a Gateway or ATA to the System" on page
To upgrade the ATA software to the latest version:
1. Press
press
2. Press
software upgrade process. The device initiates a link to the Synapse software updates
web site host and any new software.
If a host cannot be found or the server name cannot be resolved, Timeout or

Host Not Found appears. Upgrade the software from the PC, which can offer
more information about connection issues.
Getting Started
in the ATA main menu until Configuration is highlighted, as
/
Figure 41. ATA Configuration
in the ATA main menu until Configuration is highlighted and
/
to display the Configuration menu.
to highlight Upgrade Software and press
69
to display the Configuration menu. The current
"Updating Devices" on
Back to Contents
for
. If new
again to accept the
102.
to initiate the