Wall Mounting - AT&T SB67010 PSTN Installation Manual

Synapse Installation Guide

Wall Mounting

You can mount the Gateway or ATA to a wall using the two mounting slots on the bottom
of the device. Ensure that the device is oriented as shown in Figure 11 to allow air to
flow vertically through the ventilation holes on each side of the device.
To mount the Gateway or ATA to a wall:
1. Install two pan-head screws (with ¼-inch diameter head) 7 ⅞ inches (20 cm) apart.
The screw shaft diameter should be ⅛-inch (3.2 mm). Ensure you use anchors
appropriate for your mounting surface. Leave about ⅛-inch (3.2 mm) clearance
between the screw head and the wall.
2. Position the device with the mounting slot centers aligned over the mounting screws.
Carefully bring the device down onto the screws.
3. Slide the device downwards so that the screws go into the mounting slots on the
device. Ensure the device is secure.
Installation
Figure 11. Wall Mount Orientation
31
Back to Contents