AT&T SB67010 PSTN Installation Manual page 64

Synapse Installation Guide
4. Enter the static IP address for the Gateway. An IP address consists of four "octets."
Each octet is usually represented by three digits. For octets with less than three
digits, omit digits by leaving them at zero. For example, you would enter
192.168.0.20 as 192.168.000.020.
Change each number with the up and down arrow buttons and press SELECT to

move to the next number.
Press CANCEL to move back a space.

Pressing CANCEL repeatedly will take you to the previous screen.

Pressing and holding CANCEL for 2 seconds will take you to the Configuration

menu.
5. Enter the Subnet Mask.
6. Enter the Gateway.
7. Enter the DNS Server address.
8. After entering the last digit and pressing SELECT , the Configuration menu appears
again. The [*] indicates that the Gateway is now using Static IP.
Getting Started 63
Back to Contents