AT&T SB67010 PSTN Installation Manual page 131

Synapse Installation Guide
Single-zone OHP on AUX OUT is not working and the AUX OUT LED (right of the ATA LCD screen) is
solid GREEN and the WebUI is configured for paging through the AUX OUT jack.
Cause
The ATA has detected a cable
connected to the AUX OUT
jack. There may be a problem
with your paging equipment
or its configuration.
Single-zone OHP on AUX OUT is not working and the AUX OUT LED (right of the ATA LCD screen) is
flashing GREEN.
Cause
Paging is active (a user on
the system is paging the
OHP system). There may be a
problem with the paging
equipment or its setup.
In single-zone paging, paging starts on Desksets before the paging starts on the OHP system.
Cause
Paging delay is too short.
Troubleshooting
Action
Refer to your OHP product documentation for

installation and configuration instructions.
To isolate OHP-related problems, connect PC

speakers to the AUX OUT jack configured for
paging. If the page is broadcast through the
speakers when paged, refer to the documentation
that came with your OHP.
Verify your paging equipment configuration.

Check to see if the OHP system has settings that
need to be adjusted to work with Synapse. Refer
to your paging equipment documentation or to
your VAR.
Action
Verify your paging equipment configuration.

Check to see if the OHP system has settings that
need to be adjusted to work with Synapse. Refer
to your paging equipment documentation or to
your installer.
Action
Verify that the Paging Delay is set to an

appropriate delay to work with your OHP system.
a. Log on to the WebUI as administrator, click
System Settings, then Overhead Paging.
b. Set the Paging Delay.
c. Click .
130
Back to Contents