Reset The Control Panel - Bosch AMAX panel 4000 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
Dialer Event Log
Enter your code + [2] [4] and press [#]. It beeps twice.
Press [▲] or [▼] to move up and down in the Event Logs
Press [ #] To exit the Event Log
10.6

Reset the Control Panel

This function allows code holders to reset all Alarms, Faults and Tamper conditions.
Enter your code + [6][#].
The keypad beeps twice and the signal is eliminated.
Notice!
You can reset alarms, faults or tamper conditions, only when they are not active anymore.
10.7 Bypassing
10.7.1 Bypassing Zones
By bypassing Zones, one or more zones are disabled for one arming cycle. After bypassing a
zone, you can arm the system even when a zone is in alarm state.
How to Bypass a Zone
a) Enter your code + [3] [1] and press [#]. The STAY indicator flashes fast.
b) Enter the zone number you wish to bypass, then press the [*] key.
(If you wish to bypass multiple zones, please repeat step b).
c) Press [#] to exit.
How to Unbypass a Zone
LED Keypad
a) Enter your code + [3] [1] and press [#] . The STAY indicator flashes fast.
b) Enter the zone number you wish to unbypass, then press the [*] key.
(If you wish to unbypass multiple zones, please repeat step b).
c) Press [#] to exit.
Text Keypad:
a) Enter your code + [3] [2] and press [#] . The STAY indicator flashes fast.
b) Enter the zone number you wish to unbypass, then press the [*] key.
(If you wish to unbypass multiple zones, please repeat step b)
d) Press [#] to exit.
Bypassing Faults and Tamper conditions (Except Zone Tampers)
One or more faults and tamper conditions are disabled for one arming cycle. After bypassing a
Fault or Tamper condition, you can arm the system even when a Fault or Tamper condition
exists.
How to bypass a Fault or Tamper Condition
Bosch Sicherheitsysteme GmbH Installation Guide
Keypad Usage and Operations | en
2013.07 | 03 | F.01U.267.112
163