Appendices; Requirements In Accordance With Vds Class C; Selecting The Default Setting; Power Supply For Areas - Bosch ICP-MAP5000-2 Installation Manual

72 en | Appendices
8

Appendices

This chapter contains information and instructions for creating programming that complies
with the requirements of a specific standard.
Notice!
Use the default setting for parameters that are not explicitly mentioned in this description. In
addition, the instructions for panel validation in the RPS for MAP programming software
must be followed.
8.1

Requirements in accordance with VdS class C

8.1.1

Selecting the default setting

4
See also
–
8.1.2

Power supply for areas

Refer to Connecting the LSN gateway, page 46.
8.1.3

Control centers and display panel

Refer to:
–
–
–
–
–
8.1.4

Connection to a management system

Refer to IP Interface, page 57.
8.1.5

Printer connection

Connecting the DR2020T printer is permitted only for service purposes.
8.1.6

Access levels

The standard distinguishes between four access levels (AE):
–
–
–
–
Selecting the access level
AE 1 Access for everyone, no authorization/code required
AE 2 Access for users, user passcode required
AE 3 Access for installers via control center
1.
2.
AE 3 Access for installers via RPS for MAP
2016.06 | 17 | F.01U.168.332
Select VdS class C as the default property values setting.
Standard-compliant programming, page 59
Connecting the control center, page 43
Connecting the operating and display panel, page 54
Programming instructions for ISP-EMIL 120, page 56
Planning the system with IPP-MAP0005 power supply, page 7
Planning the system with ICP-MAP0012 CAN splitter module, page 10
AE 1 Access for everyone, no authorization/code required
AE 2 Access for users, user passcode required
AE 3 Access for installers via control center or via RPS for MAP
AE 4 Access for manufacturers via RPS for MAP
Open control panel enclosure.
Switch to installer mode (refer to Installer button, page 67).
Enter installer passcode.
Installation manual
MAP 5000
Bosch Sicherheitssysteme GmbH