Comms Programming Commands; Check Web Email; Email System Log; Start Direct Link - Bosch solution 6000 Installation Manual

Solution 6000
Installation Manual

Comms > Commands >

Check Web Email

Reserved
Comms > Commands >

Email System Log

Reserved
Comms > Commands >

Start Direct Link

This menu allows the installer or master user to start a
direct link session without the need to press and hold the
default button on the control panel.
1) Enter [MENU] + [5] + [0] + [5]. The keypad will
display the following:
Waiting for Direct Link
Attempt!
Press OK or MENU
Once the computer and control panel establishes a
connection, the command will automatically exit.
2) Press [OK] or [MENU] to exit.
9-2
Comms Programming

-
  MENU 5-0-3
-
  MENU 5-0-4
-
  MENU 5-0-5
Comms > Commands >

Voice Setup

This menu allows the master user to record their own
customised greeting and zone description message that
will be played back to users that are programmed to
receive domestic telephone calls from the alarm system.
These messages should be clear enough so that the user
receiving the telephone call from the control panel can
then take the appropriate action.
This feature requires an optional voice module to be
fitted to the control panel by your installer. Additional
programming information is included with the voice
module.
When answering an incoming voice call, the operations
are as follows:
[#] Acknowledge single message
[*] [*] Acknowledge all messages, hang up and leave in
cue for next person.
[*] Acknowledge message and leave in the cue for
next person
PIN Disarm the system and abort all pending voice
[OFF] messages (except Open/Close)

Solution 6000 Control Panel

1) Press [MENU] + [5] + [0] + [6] + [OK].
Enter the telephone number of the mobile phone
you are using to record the messages from. (eg.
0411123456), then press the [OK] key. The alarm
system will now call the programmed number.Answer
the incoming call on the mobile telephone and you
will hear the following message;
Press 1 to play a message,
2 to record a message
or 3 to end.
2) The alarm keypad will display the available options
on the display awaiting your selection. Using the
alarm keypad enter the number corresponding to
the operation you want to perform.
Play Message
Record Message
Exit

PRESS OK or MENU
3) Press [1] on the alarm keypad to playback and
listen to a message, or press [2] to record a new
message.
-
  MENU 5-0-6
Bosch Security Systems 07/14 BLCC610I