Bosch AMAX panel 4000 Installation Manual page 42

42 en | Settings
Zone Tamper Alarm
In case of zone tamper event, the tamper report will be sent. When zone tamper recovers, the
system status report will be sent.
Arming/Disarming Reporting (System)
The system disarming report is sent at the disarming command and the system arming report
is sent when the arming succeeds.
Duress Report
The duress report is sent at the disarming command. The duress report will not be sent in the
operation of arming, but sent as ordinary arming report. The duress report has not
corresponding alarm recovery report.
Key Switch Arming
Send system arming report when the transient key switch or locking key switch is used to arm
areas.
Quick Arming
Send system arming report when the keypad is used for quick arming.
Telephone Arming
Send system arming report when the telephone is used for arming of the panel.
Telephone arming is only available when there is only 1 Area in the system.
RPC Arming
Send system arming report when the remote PC is used to arm areas through network or
telephone connection.
Arming/Disarming Reporting (Perimeter)
The perimeter disarming report is sent at the disarming command and the perimeter arming
report is sent when the arming succeeds.
Quick Arming
Send perimeter arming report when the keypad is used for quick arming.
RPC Arming
Send perimeter arming report when the remote PC is used to arm areas through network or
telephone connection.
System Status Reporting
External Module Fault Report
–
–
–
–
–
–
–
2013.07 | 03 | F.01U.267.112
System tamper report: In case of case tamper event, the system tamper report will be
sent. When case tamper recovers, a tamper recovery report will be sent.
Zone Expansion Module Fault: When zone expansion module 1 – 6 fails, the report will be
sent; after the fault is recovered, the recovery report will be sent.
Output Expansion Module Fault: When output expansion module 1 or 2 fails, the report
will be sent; after the fault is recovered, the recovery report will be sent.
Network Module Fault: When network module 1 or 2 fails, the report will be sent; after
the fault is recovered, the recovery report will be sent.
Keypad Fault: When fault occurs between the keypad and the alarm control panel, the
report will be sent; after the fault is recovered, the recovery report will be sent.
Zone Expansion Module Tamper: When tamper occurs in the zone expansion module, the
tamper report will be sent; when the tamper recovers, a tamper recovery report will be
sent.
Keypad Tamper: When tamper occurs in any keypads, the tamper report will be sent;
when the tamper recovers, a tamper recovery report will be sent.
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitsysteme GmbH
EN