Advertisement
.
5.0 Low Battery Indication
The RF1100E indicates a low battery condition in two
ways:
•
If the LEDs are enabled, both flash simultaneously
every second.
•
During each transmission, a battery status
indication is sent to the control panel.
The LED flashing and a low battery indication at the
control panel are independent of each other and do not
necessarily occur at the same time. Receiving either
condition indicates a low battery.
7.0
Specifications
Table 2: RF1100E Specifications
Dimensions
Operating Temperature
Frequency
Operating Voltage
Battery Life
Recommended Battery Types
Compatible Receivers
Acoustic Capabilities
Bosch Security Systems | 6/04 | 4998138687C
RF1100E | Installation Instructions | 5.0
12.2 cm x 10.6 cm x 3.2 cm
0°C to +50°C
433.42 MHz
3 V
At least two years under normal operating conditions. Test with the recommended battery types.
Two AA Alkaline
RF3212E, RF3222E, or RF3227E
Glass Types and Thicknesses
Minimum pane size for all types
of glass
Minimum wall or barrier width
for mounting glass
Range
Sensitivity Settings
6.0 Control Panel Programming
A two-part RF ID sticker (Item 1 in Figure 9 on page 6)
is located inside the transmitter portion of the
RF1100E. The number on this sticker is needed to
program the transmitter into the control panel. Refer to
your control panel's programming guide for
programming information on wireless type devices.
®
Duracell
MN1500 or PC1500
Eveready ™
E91
®
Panasonic
AM-3PIXB
Type
Thickness
Plate
0.24 cm to 0.95 cm
Tempered
0.32 cm to 0.95 cm
Laminated*
0.32 cm to 1.43 cm
Wired:
0.64 cm
* protected only if both panes of glass are broken
28 cm x 28 cm
0.9 m
Maximum 7.6 m
Use DIP switches to set sensitivity levels to reduce false alarms:
•
Maximum
•
Medium
Low Battery Indication
•
Low
•
Lowest
7
Advertisement
