Serial Command Table - RTS Cronus Manual

Cronus

Serial Command Table

Serial Command Table
TABLE 9.
Command
set rvon
set rvon ip_addr
set rvon netmask
set rvon gateway
set rvon user
set rvon password
set rvon vad_threshold
set channel [chan]
set channel [chan] dest_ip
set channel [chan] dest_type
set channel [chan] chan_codec
set channel [chan] onhook
set channel [chan] offhook
set emac auto*
set emac 10 half
set emac 10 full
set emac 100 half
set emac 100 full
set serial ip_addr
set serial baud
activate
Bosch Security Systems, Inc.
Variable 1 Variable 2
X.X.X.X
X.X.X.X
X.X.X.X
abcdefg
abcdefg
[adaptive #]
X.X.X.X
X
X
X.X.X.X
X
Technical Manual
Description
Help window which lists all set rvon commands.
Set the IP Address for the RVON Card.
Set network mask for the RVON Card.
Set the gateway IP Address for the RVON-8 card.
Set the RVON user name for telnet access.
Default is telex
Set the RVON password for telnet access (8–40
characters).
Default is password
Set the VAD threshold (silence detection) Adaptive refers
to auto-select. The # can be
-20 to +10dBm.
Help window which lists all set tcid commands (TCID 0-
7).
Set the destination IP Address for this particular
RVON_Channel (same as tcid).
dest_type X = 0 (rvon-8 or rvon-C), 1 (rvon-1), 2 (rvon-I/
O).
Set the profile, which includes the compression codec see
below (0-27).
Force the channel to disconnect the port.
Force the channel to connect the port.
Enables auto-negotiation of the Ethernet interface
configuration.
Configures the Ethernet interface for 10Mbps half-
duplex.
Configures the Ethernet interface for 10Mbps full-duplex.
Configures the Ethernet interface for 100 Mbps half-
duplex.
Configures the Ethernet interface for 100 Mbps full-
duplex.
Set the destination IP Address for this serial pass-through
port.
Set the baud rate to use: 50 through 115000.
Must do an activate command to cause changes to take
effect.
75
F.01U.118.890 Rev. 23