This guide explains briefly how to install and configure an RVON-C card in a Cronus system. It contains the following
sections
Step 1
Install the front card and the back card into Cronus. See"Install Front and Back Cards in Cronus" on
page 79.
Step 2
Connect Ethernet. See "Connect Ethernet" on page 79
Step 3
Connect to Cronus frame in AZedit. See "Launch AZedit and Connect to the Cronus Frame" on page 80
Step 4
Configure the RVON-C card. See "Configure the RVON-C Card" on page 81.
Step 5
Configure the devices the card will connect with. See "Configure the Devices Connected to the RVON-C
Card" on page 83.
Step 6
Begin Operation.
NOTE:
If you are connecting using Serial Pass-Through Port, See "RVON-C Card Serial Port Programming" on page 71.
Install Front and Back Cards in Cronus
When inserting the RVON-C card into Cronus, the following considerations need to be made:
•
Gently insert the RVON-C card into the correct slot. If the card is forced or twisted while inserting, a pin
on the backplane could short or break causing the card to become inoperable.
•
When inserting the RVON-C card into Cronus, be sure to insert it into a compatible back card. If the
card is inserted into an incompatible back card, undesirable results can occur.
Connect Ethernet
Verify there is an Ethernet connection from the RVON-C card (J2 Ethernet on the back of the Cronus) to the network.
Bosch Security Systems, Inc.
RVON-C Quick Start
Technical Manual
APPENDIX C
F.01U.118.890
Rev. 23