Connecting Cronus To The Pc And The Network - RTS Cronus Manual

30 Ethernet Setup for Cronus

Connecting Cronus to the PC and the Network

IMPORTANT: The PC must be running version 2.06.07 or later of AZedit and have an Ethernet card installed.
Verify Cronus is connected to the PC using either a USB (universal) or RS-232 (ADAM standard) cable. The USB drivers can
be found in the AZedit software directory (C:\Telex\AZedit|V20701|USB). You may only use one USB connection (front
panel or back panel) at a time.
NOTE: Cronus can support up to 32 multiple sessions of AZedit on Ethernet.
To connect Cronus to the PC with a serial cable, do the following:
NOTE: For more information on Network Basics, "Basic Network Configuration" on page 61.
Open AZedit.
1.
The Keypanels/Ports window appears.
From the Options menu, select Ethernet Setup.
2.
The Ethernet Setup Window appears.
In the IP Address field, enter the IP Address for the Cronus system.
3.
In the Network Mask field, enter the Network Mask number for the Cronus System.
4.
Where appropriate, in the Default Gateway field, enter the gateway number for Cronus.
5.
NOTE: If you do not know these numbers, your system administrator can give you the IP Address and Netmask to
use.
Click Apply.
6.
Click Close.
7.
The Ethernet Setup window is closed.
Connect the Cronus to your network with an Ethernet cable.
8.
Connect the PC to you network with an Ethernet cable.
9.
Bosch Security Systems, Inc.
Technical Manual
Cronus
F.01U.118.890 Rev. 23