Rvon-C Default Setup - RTS Cronus Manual

78

RVON-C Default Setup

The board is shipped from the factory containing the following:
All are set rvon commands
Variable Environment Name
ip_addr EMACA_IPADDR
netmask EMACA_NETMASK
gateway EMACA_GW
serial_ip RVON_SERIAL_IP
serial_baud RVON_SERIAL_ Baud
user RVON_USER
password RVON_PASSWORD
vad_threshold RVON_THRESHOLD_VAD
There are more parameters that the software will auto-configure if they have not been previously setup. The user can also set
these parameters, in which case the software would not modify but take them as they are.
All are set chan # commands because they are for each audio channel.
Variable Environment Name
dest_ip RVON_DEST_IP_#
dest_type RVON_DEST_TYPE_3
dest_chan RVON_DEST_CHAN_#
chan_codec RVON_CHAN_CODEC_#
Typing printenv, then pressing Return from an RVON-C boot code or sys-printenv from the MXP Debug System Prompt may
show these commands. The Environment name is listed because this is the label used by the software.
IMPORTANT: If the user is attempting to do a setenv to change a parameter from the RVON-C boot code, the
Environment Name must be used and not the set rvon variable name.
Bosch Security Systems, Inc.
Default Value
x.x.x.x IP Address for the RVON-C Card
255.255.255.0 Network Mask for the RVONC card
none Gateway IP Address for the RVON-C Card
none Pass-thru serial port IP Address for the RVON-C Card
9600 Set the pass-thru serial port baud rate for the RVON-C
Card
telex RVON-C user name for telnet access
password RVON-C password for telnet access (8-40 characters)
10 VAD Threshold
Default Value
X.X.X.X Destination IP Address for this particular RVON_CH
X Destination Type Y= 0 (RVON-C), 1 (rvon-1), 2 (rvon-I/
O)
X Destination Channel - what port of far end (0-7)
X Profile to use (previous coding table)
Technical Manual
Cronus
Description
Description
F.01U.118.890 Rev. 23