Rvon Serial And Telnet Commands; Setup - RTS Cronus Manual

RVON Serial and Telnet Commands

RVON-C card programming can be done via direct serial or telnet connection. There are several physical connections to an
RVON-C card.
• Direct serial through custom debug cable (J7 6-pin bottom front).
The customer debug cable always functions as the general purpose debug tool.
• Backcard DB-9 J1
The backcard DB-9 (must be disabled/enabled via a DIP Switch because it can also be used for serial
port
pass-through.
The backcard DB-9 can be used for debug terminal when DIP Switch 6 is switched to the Closed
position.
• Backcard RJ-45 J2 (Telnet Only)

Setup

Serial Port
Telnet
Bosch Security Systems, Inc.
38,400 baud, no flow control
IP Address, port 23
Serial Port Programming
Technical Manual
APPENDIX B
RVON-C Card
F.01U.118.890 Rev. 23