RTS Cronus Manual page 65

Cronus
RVON-C Status Descriptions
TABLE 4.
ACTION
When Ethernet is selected:
When Serial is selected:
When VoIP Channel is selected:
Bosch Security Systems, Inc.
Link Up - Displays whether the Ethernet link is active or inactive.
Link Up - Active, Link Down – Inactive
Speed - Displays the connection speed in mbps. Can be either 10mbps or 100mbps.
Mode - Displays whether the connection is Half Duplex (data that moves in one
direction) or Full Duplex (data that moves in both directions).
Auto-Negotiate - Automatically determines the Ethernet speed and mode, and then
adjusts the settings accordingly.
IP - Displays the IP Address of where the transfer is being sent.
Baud - Displays the connection speed of the RVON-C.
To Net - Displays the number of bytes that have been transferred from the serial port.
To Ser - Displays the number of bytes that have been transferred to the serial port.
VoIP........ Displays the channel connection status to other RVON devices. The
channel connection shows connections to RVON-8, RVON-I/O,
RVON-1, RVON-C, and VKP.
Each dot or check mark represents a channel connection. There are
eight (8) channel connections for each RVON-C card.
If a dot (•) is seen in the display, this means that the channel is not
connected to a RVON device.
If a check mark () is seen in the display, this means that the channel
is connected to an RVON device.
Panels......... Displays whether or not there is a keypanel connected at the other end
of the channel connections.
Each dot or check mark represents a channel connection. There are
eight (8) channel connections for each RVON-C card.
If a dot (•) is seen in the display, this means that the channel is not
connected to a keypanel.
If a check mark () is seen in the display, this means that the channel
is connected to a keypanel.
NOTE: Channels are ordered from left to right.
Technical Manual
RVON-C RTS Voice Over Network for Cronus 57
DISPLAY
F.01U.118.890 Rev. 23