Field Setting Of Outdoor Unit; Field Setting From Remote Controller - Daikin SkyAir RZQ200 · 250C7Y1B Service Manual

Field Setting of Outdoor Unit

2. Field Setting of Outdoor Unit

2.1

Field Setting from Remote Controller

2.1.1 Remote Controller Settings
Field setting, which was conventionally done only from outdoor units, can be partly performed
from a remote controller. The setting procedure is same as that for indoor unit.
The table below contains the remote controller settings.
Mode No. First Description
code
16 or 26 0 Select from "Low Night
Noise Setting",
"Capacity Precedence
Setting".
1 Setting of "starting
time", and "ending time"
for the Low Night Noise
Setting.
2 Selection of Flat
Installation
3
Note 1. Setting in Mode No. 16 is group setting. For individual setting of each outdoor unit, use
2. The factory settings for Second Code No. are shown in the boxes with thick lines in the table
3. When returning to Normal Mode, "88" may appear to initialize the remote controller.
4. Do not set anything not shown above.
2.1.2 Field Setting Procedure
1. When in the normal mode, press the "
2. Select the desired MODE NO. with the "
3. During group control, when setting by each indoor unit (mode No. 20, 21, 22 and 23 have
4. Push the "
5. Push the "
6. Push the "
7. Push the "
32
Second No.
01
Disabled
(Factory
setting)
22h00~
06h00
Disabled
(Factory
setting)
Standard
(Factory
setting)
Mode No. 26 and make settings for each indoor unit connected.
above.
FIELD SET MODE is entered.
been selected), push the "
operation is unnecessary when setting by group.)
" upper button (4) and select FIRST CODE NO.
" lower button (5) and select the SECOND CODE NO.
" button (6) once and the present settings are SET.
" button (7) to return to the NORMAL MODE.
02 03
Automatic Low Night
low noise Noise
activation setting +
Capacity
precedence
setting
22h00~ 22h00 ~ 22h00 ~
08h00 06h00 08h00
(Factory
setting)
— —
Delayed Early
defrost defrost
start start
" button for a minimum of four seconds, and the
" button (2).
" button (3) and select the INDOOR UNIT NO to be set. (This
: Factory settings
04 05 06
— — —
20h00 ~ 22h00~
08h00 08h00
— Flat —
installation
applicable
— — —
SiBE26-701
07
—
20h00 ~
08h00
—
—
Field Setting