Configuring Static Smartports Macros; Default Static Smartports Configuration; Static Smartports Configuration Guidelines - Cisco Catalyst 3750-X Software Configuration Manual

Chapter 14 Configuring Auto Smartports Macros
Table 14-3
Command
until
while

Configuring Static Smartports Macros

•
•
•

Default Static Smartports Configuration

There are no static Smartports macros enabled on the switch.
Table 14-4 Default Static Smartports Macros
1
Macro Name Description
Use this global configuration macro to enable rapid PVST+, loop guard, and dynamic port error recovery
cisco-global
for link state failures.
Use this interface configuration macro for increased network security and reliability when connecting a
cisco-desktop
desktop device, such as a PC, to a switch port.
Use this interface configuration macro when connecting a desktop device such as a PC with a Cisco IP
cisco-phone
Phone to a switch port. This macro is an extension of the cisco-desktop macro and provides the same
security and resiliency features, but with the addition of dedicated voice VLANs to ensure proper
treatment of delay-sensitive voice traffic.
Use this interface configuration macro when connecting an access switch and a distribution switch or
cisco-switch
between access switches connected by using small form-factor pluggable (SFP) modules.
Use this interface configuration macro when connecting the switch and a WAN router.
cisco-router
Use this interface configuration macro when connecting the switch and a wireless access point.
cisco-wireless
1. Cisco-default Smartports macros vary, depending on the software version running on your switch.

Static Smartports Configuration Guidelines

•
•
•
OL-21521-01
Unsupported Cisco IOS Shell Reserved Keywords (continued)
Description
Looping construct.
Looping construct.
Default Static Smartports Configuration, page 14-17
Static Smartports Configuration Guidelines, page 14-17
Applying Static Smartports Macros, page 14-18
When a macro is applied globally to a switch or to a switch interface, all existing configuration on
the interface is retained. This is helpful when applying an incremental configuration.
If a command fails because of a syntax or a configuration error, the macro continues to apply the
remaining commands. You can use the macro global trace macro-name global configuration
command or the macro trace macro-name interface configuration command to apply and debug a
macro to find any syntax or configuration errors.
Some CLI commands are specific to certain interface types. If you apply a macro to an interface that
does not accept the configuration, the macro fails the syntax or the configuration check, and the
switch returns an error message.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring Static Smartports Macros
14-17