Chapter 33 Configuring Rmon - Cisco Catalyst 3750-X Software Configuration Manual

Configuring RMON
Figure 33-1
configured. SNMP configured.
The switch supports these RMON groups (defined in RFC 1757):
•
•
•
•
Because switches supported by this software release use hardware counters for RMON data processing,
the monitoring is more efficient, and little processing power is required.
64-bit counters are not supported for RMON alarms.
Note
Configuring RMON
•
•
•
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
33-2
Remote Monitoring Example
Network management station with
generic RMON console application
RMON alarms and events
RMON history
and statistic
collection enabled.
Workstations
Statistics (RMON group 1)—Collects Ethernet statistics (including Fast Ethernet and Gigabit
Ethernet statistics, depending on the switch type and supported interfaces) on an interface.
History (RMON group 2)—Collects a history group of statistics on Ethernet ports (including Fast
Ethernet and Gigabit Ethernet statistics, depending on the switch type and supported interfaces) for
a specified polling interval.
Alarm (RMON group 3)—Monitors a specific management information base (MIB) object for a
specified interval, triggers an alarm at a specified value (rising threshold), and resets the alarm at
another value (falling threshold). Alarms can be used with events; the alarm triggers an event, which
can generate a log entry or an SNMP trap.
Event (RMON group 9)—Specifies the action to take when an event is triggered by an alarm. The
action can be to generate a log entry or an SNMP trap.
Default RMON Configuration, page 33-3
Configuring RMON Alarms and Events, page 33-3
Collecting Group History Statistics on an Interface, page 33-5
Workstations
(required)
(optional)
Chapter 33 Configuring RMON
OL-21521-01