Accessing The Cli Through A Console Connection Or Through Telnet - Cisco Catalyst 3750-X Software Configuration Manual

Accessing the CLI
To debug a specific stack member, you can access it from the stack master by using the session
stack-member-number privileged EXEC command. The stack member number is appended to the system
prompt. For example,
the system prompt for the stack master is
a CLI session to a specific stack member.

Accessing the CLI through a Console Connection or through Telnet

Before you can access the CLI, you must connect a terminal or a PC to the switch console or connect a
PC to the Ethernet management port and then power on the switch, as described in the hardware
installation guide that shipped with your switch. Then, to understand the boot process and the options
available for assigning IP information, see
Gateway."
If your switch is already configured, you can access the CLI through a local console connection or
through a remote Telnet session, but your switch must first be configured for this type of access. For
more information, see the
You can use one of these methods to establish a connection with the switch:
•
•
After you connect through the console port, through the Ethernet management port, through a Telnet
session or through an SSH session, the user EXEC prompt appears on the management station.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
2-10
Switch-2#
"Setting a Telnet Password for a Terminal Line" section on page
Connect the switch console port to a management station or dial-up modem, or connect the Ethernet
management port to a PC. For information about connecting to the console or Ethernet management
port, see the switch hardware installation guide.
Use any Telnet TCP/IP or encrypted Secure Shell (SSH) package from a remote management
station. The switch must have network connectivity with the Telnet or SSH client, and the switch
must have an enable secret password configured.
For information about configuring the switch for Telnet access, see the
for a Terminal Line" section on page
sessions. Changes made by one Telnet user are reflected in all other Telnet sessions.
For information about configuring the switch for SSH, see the
Shell" section on page 10-44. The switch supports up to five simultaneous secure SSH sessions.
is the prompt in privileged EXEC mode for stack member 2, and where
. Only the show and debug commands are available in
Switch
Chapter 3, "Assigning the Switch IP Address and Default
10-6. The switch supports up to 16 simultaneous Telnet
Chapter 2 Using the Command-Line Interface
"Setting a Telnet Password
"Configuring the Switch for Secure
10-6.
OL-21521-01