Using Interface Configuration Mode
•
•
You can identify physical interfaces by physically checking the interface location on the switch. You can
also use the show privileged EXEC commands to display information about a specific interface or all
the interfaces on the switch. The remainder of this chapter primarily provides physical interface
configuration procedures.
These are examples of how to identify interfaces on a 3750-X switch:
•
•
•
If the switch has SFP modules, the port numbers continue consecutively.To configure the first SFP
module port on stack member 1 with 16 10/100/1000 ports, enter this command:
Switch(config)# interface gigabitethernet1/0/25
Procedures for Configuring Interfaces
These general instructions apply to all interface configuration processes.
Enter the configure terminal command at the privileged EXEC prompt:
Step 1
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#
Enter the interface global configuration command. Identify the interface type, the switch number (only
Step 2
on Catalyst 3750-X switches), and the number of the connector. In this example, Gigabit Ethernet port 1
on switch 1 is selected:
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)#
Note
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
13-18
Module number—The module or slot number on the switch that is always 0.
Port number—The interface number on the switch. The 10/100/1000 port numbers always begin
at 1, starting with the far left port when facing the front of the switch, for example,
gigabitethernet1/0/1 or gigabitethernet1/0/8.
On a switch with 10/100/1000 ports and Cisco TwinGig Converter Modules in the 10-Gigabit
Ethernet module slots, the port numbers restart with the 10-Gigabit Ethernet ports:
tengigabitethernet1/0/1.
On a switch with 10/100/1000 ports and Cisco dual SFP X2 converter modules in the 10-Gigabit
Ethernet module slots, the SFP module ports are numbered consecutively following the 10/100/1000
interfaces. For example, if the switch has 24 10/100/1000 ports, the SFP module ports are
gigabitethernet1/0/25 through gigabitethernet1/0/28.
To configure 10/100/1000 port 4 on a standalone switch, enter this command:
Switch(config)# interface gigabitethernet1/0/4
To configure 10-Gigabit Ethernet port 1 on a standalone switch, enter this command:
Switch(config)# interface tengigabitethernet1/0/1
To configure 10-Gigabit Ethernet port on stack member 3, enter this command:
Switch(config)# interface tengigabitethernet3/0/1
You do not need to add aspace between the interface type and the interf ace number. For example,
in the preceding line, you can specify either gigabitethernet 1/0/1, gigabitethernet1/0/1,
gi 1/0/1, or gi1/0/1.
Chapter 13
Configuring Interface Characteristics
OL-21521-01