Displaying Mvr Information - Cisco Catalyst 3750-X Software Configuration Manual

Displaying MVR Information

Command
Step 8
show mvr
show mvr interface
or
show mvr members
copy running-config startup-config (Optional) Save your entries in the configuration file.
Step 9
To return the interface to its default settings, use the no mvr [type | immediate | vlan vlan-id | group]
interface configuration commands.
This example shows how to configure a port as a receiver port, statically configure the port to receive
multicast traffic sent to the multicast group address, configure Immediate Leave on the port, and verify
the results.
Switch(config)# mvr
Switch(config)# interface gigabitethernet1/0/2
Switch(config-if)# mvr type receiver
Switch(config-if)# mvr vlan 22 group 228.1.23.4
Switch(config-if)# mvr immediate
Switch(config)# end
Switch# show mvr interface
Port
----
Gi1/0/2 RECEIVER
Displaying MVR Information
You can display MVR information for the switch or for a specified interface.
Table 26-6 Commands for Displaying MVR Information
Command
show mvr
show mvr interface [interface-id]
[members [vlan vlan-id]]
show mvr members [ip-address] Displays all receiver and source ports that are members of any IP multicast group or the
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
26-22
Purpose
Verify the configuration.
Type Status
---- -------
ACTIVE/DOWN
Purpose
Displays MVR status and values for the switch—whether MVR is enabled or disabled,
the multicast VLAN, the maximum (256) and current (0 through 256) number of
multicast groups, the query response time, and the MVR mode.
Displays all MVR interfaces and their MVR configurations.
When a specific interface is entered, displays this information:
Type—Receiver or Source
•
Status—One of these:
•
Active means the port is part of a VLAN.
–
Up/Down means that the port is forwarding or nonforwarding.
–
Inactive means that the port is not part of any VLAN.
–
Immediate Leave—Enabled or Disabled
•
If the members keyword is entered, displays all multicast group members on this port or,
if a VLAN identification is entered, all multicast group members on the VLAN. The
VLAN ID range is 1 to 1001 and 1006 to 4094.
specified IP multicast group IP address.
Chapter 26
Immediate Leave
---------------
ENABLED
Configuring IGMP Snooping and MVR
OL-21521-01