Cisco Catalyst 3750-X Software Configuration Manual page 744

Configuring LLDP, LLDP-MED, and Wired Location Service
Command
location {additional-location-information
Step 5
word | civic-location-id id | elin-location-id
id}
Step 6
end
Step 7
show location
Step 8
copy running-config startup-config
Use the no form of each command to return to the default setting.
This example shows how to configure civic location information on the switch:
Switch(config)# location civic-location identifier 1
Switch(config-civic)# number 3550
Switch(config-civic)# primary-road-name "Cisco Way"
Switch(config-civic)# city "San Jose"
Switch(config-civic)# state CA
Switch(config-civic)# building 19
Switch(config-civic)# room C6
Switch(config-civic)# county "Santa Clara"
Switch(config-civic)# country US
Switch(config-civic)# end
Beginning in privileged EXEC mode, follow these steps to enable wired location service on the switch.
Command
Step 1
configure terminal
Step 2
nmsp enable
nmsp notification interval {attachment |
Step 3
location} interval-seconds
Step 4 end
Step 5
show network-policy profile
Step 6
copy running-config startup-config
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
30-10
Chapter 30 Configuring LLDP, LLDP-MED, and Wired Location Service
Purpose
Enter location information for an interface:
additional-location-information—Specify additional information
for a location or place.
civic-location-id—Specify global civic location information for an
interface.
elin-location-id—Specify emergency location information for an
interface.
id—Specify the ID for the civic location or the ELIN location. The ID
range is 1 to 4095.
word—Specify a word or phrase with additional location
information.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Enable the NMSP features on the switch.
Specify the NMSP notification interval.
attachment—Specify the attachment notification interval.
location—Specify the location notification interval.
interval-seconds—Duration in seconds before the switch sends the
MSE the location or attachment updates. The range is 1 to 30; the
default is 30.
Return to privileged EXEC mode.
Verify the configuration.
(Optional) Save your entries in the configuration file.
OL-21521-01