Cisco Catalyst 3750-X Software Configuration Manual page 745

Chapter 30 Configuring LLDP, LLDP-MED, and Wired Location Service
This example shows how to enable NMSP on a switch and to set the location notification time to 10
seconds:
Switch(config)# nmsp enable
Switch(config)# nmsp notification interval location 10
Monitoring and Maintaining LLDP, LLDP-MED, and Wired
Location Service
Command
clear lldp counters
clear lldp table
clear nmsp statistics
show lldp
show lldp entry entry-name
show lldp interface [interface-id]
show lldp neighbors [interface-id]
[detail]
show lldp traffic
show location
show network-policy profile
show nmsp
OL-21521-01
Monitoring and Maintaining LLDP, LLDP-MED, and Wired Location Service
Description
Reset the traffic counters to zero.
Delete the LLDP neighbor information table.
Clear the NMSP statistic counters.
Display global information, such as frequency of transmissions, the holdtime for
packets being sent, and the delay time before LLDP initializes on an interface.
Display information about a specific neighbor.
You can enter an asterisk (*) to display all neighbors, or you can enter the
neighbor name.
Display information about interfaces with LLDP enabled.
You can limit the display to a specific interface.
Display information about neighbors, including device type, interface type and
number, holdtime settings, capabilities, and port ID.
You can limit the display to neighbors of a specific interface or expand the display
for more detailed information.
Display LLDP counters, including the number of packets sent and received,
number of packets discarded, and number of unrecognized TLVs.
Display the location information for an endpoint.
Display the configured network-policy profiles.
Display the NMSP information.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
30-11