Using Interface Configuration Mode - Cisco Catalyst 3750-X Software Configuration Manual

Chapter 13 Configuring Interface Characteristics
This is sample output from the show usb port command:
Switch# show usb port
Port Number: 0
Status: Enabled
Connection State: Connected
Speed: High
Power State: ON

Using Interface Configuration Mode

The switch supports these interface types:
•
•
•
You can also configure a range of interfaces (see the
page
To configure a physical interface (port), specify the interface type, stack member number (only
Catalyst 3750-X switches), module number, and switch port number, and enter interface configuration mode.
•
•
OL-21521-01
Interface:
Number: 0
Description: Bulk
Class Code: 8
Subclass: 6
Protocol: 80
Number of Endpoints: 2
Endpoint:
Number: 1
Transfer Type: BULK
Transfer Direction: Device to Host
Max Packet: 512
Interval: 0
Endpoint:
Number: 2
Transfer Type: BULK
Transfer Direction: Host to Device
Max Packet: 512
Interval: 0
Physical ports—switch ports and routed ports
VLANs—switch virtual interfaces
Port channels—EtherChannel interfaces
13-19).
Type—Gigabit Ethernet (gigabitethernet or gi) for 10/100/1000 Mb/s Ethernet ports, 10-Gigabit
Ethernet (tengigabitethernet or te) for 10,000 Mb/s, or small form-factor pluggable (SFP) module
Gigabit Ethernet interfaces (gigabitethernet or gi).
Stack member number—The number that identifies the switch within the stack. The switch number
range is 1 to 9 and is assigned the first time the switch initializes. The default switch number, before
it is integrated into a switch stack, is 1. When a switch has been assigned a stack member number,
it keeps that number until another is assigned to it.
You can use the switch port LEDs in Stack mode to identify the stack member number of a switch.
For information about stack member numbers, see the
page 5-7.
"Configuring a Range of Interfaces" section on
"Stack Member Numbers" section on
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Using Interface Configuration Mode
13-17