Cisco Catalyst 3750-X Software Configuration Manual page 817

Chapter 35 Configuring SNMP
Command
Step 6
snmp-server enable traps
notification-types
Step 7
snmp-server trap-source interface-id
Step 8
snmp-server queue-length length
Step 9
snmp-server trap-timeout seconds
Step 10
end
Step 11
show running-config
Step 12
copy running-config startup-config
The snmp-server host command specifies which hosts receive the notifications. The snmp-server
enable trap command globally enables the mechanism for the specified notification (for traps and
informs). To enable a host to receive an inform, you must configure an snmp-server host informs
command for the host and globally enable informs by using the snmp-server enable traps command.
To remove the specified host from receiving traps, use the no snmp-server host host global
configuration command. The no snmp-server host command with no keywords disables traps, but not
informs, to the host. To disable informs, use the no snmp-server host informs global configuration
command. To disable a specific trap type, use the no snmp-server enable traps notification-types global
configuration command.
OL-21521-01
Purpose
Enable the switch to send traps or informs and specify the type of
notifications to be sent. For a list of notification types, see
page 35-12, or enter snmp-server enable traps ?
To enable multiple types of traps, you must enter a separate snmp-server
enable traps command for each trap type.
When you configure a trap by using the notification type
Note
port-security, configure the port security trap first, and then
configure the port security trap rate:
snmp-server enable traps port-security
•
snmp-server enable traps port-security trap-rate rate
•
(Optional) Specify the source interface, which provides the IP address for
the trap message. This command also sets the source IP address for
informs.
(Optional) Establish the message queue length for each trap host. The
range is 1 to 1000; the default is 10.
(Optional) Define how often to resend trap messages. The range is 1 to
1000; the default is 30 seconds.
Return to privileged EXEC mode.
Verify your entries.
To display SNMPv3 information about auth | noauth | priv mode
Note
configuration, you must enter the show snmp user EXEC
command.
(Optional) Save your entries in the configuration file.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring SNMP
Table 35-5 on
35-15