Configuring Poe Port Priority - Cisco Catalyst 3750-X Software Configuration Manual

Configuring Stack Power
Entering the write erase and reload privileged EXEC commands down not change the power priority or
Note
power mode non-default configuration saved in the switch flash memory.

Configuring PoE Port Priority

Beginning in privileged EXEC mode, follow these steps to configure the priority of a PoE port on a
switch:
Command
Step 1
configure terminal
Step 2
interface interface-id
power inline port priority {high | low}
Step 3
Step 4
end
Step 5 show power inline priority
Step 6 copy running-config startup-config
This is an example of setting the power priority of a port to high so that it is one of the last ports to shut
down in case of a power failure.
Switch(config)# interface gigabitetherent1/0/1
Switch(config-if)# power inline port priority high
Switch(config-if)# exit
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
9-8
Chapter 9
Purpose
Enter global configuration mode.
Enter the interface ID of the port in the stack and enter interface
configuration mode. The interface must be a PoE port.
Set the power priority of the port to high or low. Powered devices
connected to low priority ports are shut down first in case of a
power reduction. The default is low priority.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Configuring Catalyst 3750-X StackPower
OL-21521-01