Supported Features On The Ethernet Management Port; Configuring The Ethernet Management Port - Cisco Catalyst 3750-X Software Configuration Manual

Chapter 13 Configuring Interface Characteristics

Supported Features on the Ethernet Management Port

The Ethernet management port supports these features:
•
•
•
•
•
•
•
•
•
•
•
•
•
Before enabling a feature on the Ethernet management port, make sure that the feature is supported. If
Caution
you try to configure an unsupported feature on the Ethernet Management port, the feature might not work
properly, and the switch might fail.

Configuring the Ethernet Management Port

To specify the Ethernet management port in the CLI, enter fastethernet0.
To disable the port, use the shutdown interface configuration command. To enable the port, use the no
shutdown interface configuration command.
To find out the link status to the PC, you can monitor the LED for the Ethernet management port. The
LED is green (on) when the link is active, and the LED is off when the link is down. The LED is amber
when there is a POST failure.
To display the link status, use the show interfaces fastethernet 0 privileged EXEC command.
OL-21521-01
Express Setup (only in switch stacks)
Network Assistant
Telnet with passwords
TFTP
Secure Shell (SSH)
DHCP-based autoconfiguration
SMNP (only the ENTITY-MIB and the IF-MIB)
IP ping
Interface features
Speed—10 Mb/s, 100 Mb/s, and autonegotiation
–
Duplex mode—Full, half, and autonegotiation
–
Loopback detection
–
Cisco Discovery Protocol (CDP)
DHCP relay agent
IPv4 and IPv6 access control lists (ACLs)
Routing protocols
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Using the Ethernet Management Port
13-25