Configuring The Ip-Precedence-To-Dscp Map - Cisco Catalyst 3750-X Software Configuration Manual

Chapter 39 Configuring QoS

Configuring the IP-Precedence-to-DSCP Map

You use the IP-precedence-to-DSCP map to map IP precedence values in incoming packets to a DSCP
value that QoS uses internally to represent the priority of the traffic.
Table 39-13
Table 39-13
IP Precedence Value
0
1
2
3
4
5
6
7
If these values are not appropriate for your network, you need to modify them.
Beginning in privileged EXEC mode, follow these steps to modify the IP-precedence-to-DSCP map.
This procedure is optional.
Command
Step 1
configure terminal
Step 2 mls qos map ip-prec-dscp
dscp1...dscp8
Step 3 end
Step 4
show mls qos maps ip-prec-dscp
Step 5
copy running-config startup-config
To return to the default map, use the no mls qos ip-prec-dscp global configuration command.
This example shows how to modify and display the IP-precedence-to-DSCP map:
Switch(config)# mls qos map ip-prec-dscp 10 15 20 25 30 35 40 45
Switch(config)# end
Switch# show mls qos maps ip-prec-dscp
IpPrecedence-dscp map:
OL-21521-01
shows the default IP-precedence-to-DSCP map:
Default IP-Precedence-to-DSCP Map
DSCP Value
0
8
16
24
32
40
48
56
Purpose
Enter global configuration mode.
Modify the IP-precedence-to-DSCP map.
For dscp1...dscp8, enter eight DSCP values that correspond to the IP
precedence values 0 to 7. Separate each DSCP value with a space.
The DSCP range is 0 to 63.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
ipprec: 0 1 2 3 4
--------------------------------
dscp: 10 15 20 25 30 35 40 45
5 6 7
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring Standard QoS
39-71