Using Interface Configuration Mode - Cisco Catalyst 2360 Software Configuration Manual

Chapter 8 Configuring Interface Characteristics
This is sample output from the show usb port command:
Switch# show usb port
Port Number: 0
Status: Enabled
Connection State: Connected
Speed: High
Power State: ON

Using Interface Configuration Mode

Supported interface types:
•
•
•
You can also configure a range of interfaces (see the
page
To configure a physical interface, specify the interface type, module number, and switch port number, and
enter interface configuration mode.
•
•
•
On a switch with 10/100/1000 ports and Cisco TwinGig Converter Modules in the 10-Gigabit Ethernet
module slots, the port numbers restart with the 10-Gigabit Ethernet ports: tengigabitethernet0/1.
OL-19808-01
Interface:
Number: 0
Description: Bulk
Class Code: 8
Subclass: 6
Protocol: 80
Number of Endpoints: 2
Endpoint:
Number: 1
Transfer Type: BULK
Transfer Direction: Device to Host
Max Packet: 512
Interval: 0
Endpoint:
Number: 2
Transfer Type: BULK
Transfer Direction: Host to Device
Max Packet: 512
Interval: 0
Physical ports—switch ports
VLANs—switch virtual interfaces
Port channels—EtherChannel interfaces
8-11).
Type—Fast Ethernet (fastethernet or fa) for 10/100 Mb/s Ethernet, Gigabit Ethernet (gigabitethernet
or gi) for 10/100/1000 Mb/s Ethernet ports, 10-Gigabit Ethernet (tengigabitethernet or te) for 10,000
Mb/s, or small form-factor pluggable (SFP) module Gigabit Ethernet interfaces (gigabitethernet or
gi).
Module number—The module or slot number on the switch that is always 0.
Port number—The switch port number. The 10/100/1000 port numbers always begin at 1, starting
with the far left port on the front of the switch, for example, gigabitethernet0/1 or gigabitethernet0/8.
Using Interface Configuration Mode
"Configuring a Range of Interfaces" section on
Catalyst 2360 Switch Software Configuration Guide
8-9