Vlan Mapping Commands - ZyXEL Communications Ethernet Switch Cli Reference Manual

C
HA P T E R

VLAN Mapping Commands

Use these commands to configure VLAN mapping on the Switch. With VLAN mapping
enabled, the Switch can map the VLAN ID and priority level of packets received from a
private network to those used in the service provider's network. The Switch discards the
tagged packets that do not match an entry in the VLAN mapping table.

You can not enable VLAN mapping and VLAN stacking at the same time.
80.1 Command Summary
The following section lists the commands for this feature.
Table 174 vlan mapping Command Summary
COMMAND
no vlan-mapping
no vlan-mapping interface port-
channel <port> vlan <1-4094>
no vlan-mapping interface port-
channel <port> vlan <1-4094>
inactive
vlan-mapping
vlan-mapping name <name>
interface port-channel <port>
vlan <1-4094> translated-vlan
<1-4094> priority <0-7>
vlan-mapping name <name>
interface port-channel <port>
vlan <1-4094> translated-vlan
<1-4094> priority <0-7> inactive
interface port-channel <port-
list>
vlan-mapping
no vlan-mapping
Ethernet Switch CLI Reference Guide
DESCRIPTION
Disables VLAN mapping on the Switch.
Removes the specified VLAN mapping rule.
Enables the specified VLAN mapping rule.
Enables VLAN mapping on the Switch.
Creates a VLAN mapping rule.
Disables the specified VLAN mapping rule.
Enters config-interface mode for the specified port(s).
Enables VLAN mapping on the port(s).
Disables VLAN mapping on the port(s).
80
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
305