ZyXEL Communications Ethernet Switch Cli Reference Manual page 127

29.2 Command Examples
This example looks at the current status of port 1.
sysname# show interfaces 1
Port Info
TX Packet
RX Packet
TX Collison
Error Packet
Distribution
The following table describes the labels in this screen.
Table 74 show interfaces
LABEL
Port Info
Port NO.
Link
Status
LACP
TxPkts
Ethernet Switch CLI Reference Guide
Port NO.
Link
Status
LACP
TxPkts
RxPkts
Errors
Tx KBs/s
Rx KBs/s
Up Time
Unicast
Multicast
Broadcast
Pause
Tagged
Unicast
Multicast
Broadcast
Pause
Control
Single
Multiple
Excessive
Late
RX CRC
Runt
64
65 to 127
128 to 255
256 to 511
512 to 1023
1024 to 1518
Giant
DESCRIPTION
This field displays the port number you are viewing.
This field displays the speed (either 10M for 10 Mbps, 100M for 100 Mbps
or 1000M for 1000 Mbps) and the duplex (F for full duplex or H for half
duplex). It also shows the cable type (Copper or Fiber). This field displays
Down if the port is not connected to any device.
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state
of the port. If STP is disabled, this field displays FORWARDING if the link is
up, otherwise, it displays STOP.
This field shows if LACP is enabled on this port or not.
This field shows the number of transmitted frames on this port
Chapter 29 Interface Commands
:1
:100M/F
:FORWARDING
:Disabled
:7214
:395454
:0
:0.0
:0.0
:127:26:26
:7214
:0
:163
:0
:0
:395454
:186495
:200177
:0
:0
:0
:0
:0
:0
:0
:0
:285034
:31914
:22277
:50546
:1420
:4268
:0
127