Trunk Commands - ZyXEL Communications Ethernet Switch Cli Reference Manual

C
HA P T E R
Use these commands to logically aggregate physical links to form one logical, higher-
bandwidth link. The Switch adheres to the IEEE 802.3ad standard for static and dynamic
(Link Aggregate Control Protocol, LACP) port trunking.

Different models support different numbers of trunks (T1, T2, ...). This chapter
uses a model that supports six trunks (from T1 to T6).
76.1 Command Summary
The following section lists the commands for this feature.
Table 163 trunk Command Summary
COMMAND
show trunk
trunk <T1|T2|T3|T4|T5|T6>
no trunk <T1|T2|T3|T4|T5|T6>
trunk <T1|T2|T3|T4|T5|T6>
criteria <src-mac|dst-mac|src-
dst-mac|src-ip|dst-ip|src-dst-
ip>
no trunk <T1|T2|T3|T4|T5|T6>
criteria
trunk <T1|T2|T3|T4|T5|T6>
interface <port-list>
no trunk <T1|T2|T3|T4|T5|T6>
interface <port-list>
trunk <T1|T2|T3|T4|T5|T6> lacp
no trunk <T1|T2|T3|T4|T5|T6>
lacp
trunk interface <port-list>
timeout <lacp-timeout>
Ethernet Switch CLI Reference Guide

Trunk Commands

DESCRIPTION
Displays link aggregation information.
Activates a trunk group.
Disables the specified trunk group.
Sets the traffic distribution type used for the specified trunk
group.
Returns the traffic distribution type used for the specified
trunk group to the default (src-dst-mac).
Adds a port(s) to the specified trunk group.
Removes ports from the specified trunk group.
Enables LACP for a trunk group.
Disables LACP in the specified trunk group.
Defines LACP timeout period (in seconds) for the specified
port(s).
lacp-timeout: 1 or 30
76
M P
E 3
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
289