ZyXEL Communications Ethernet Switch Cli Reference Manual page 90

Chapter 20 Ethernet OAM Commands
Table 54 ethernet oam Command Summary (continued)
COMMAND
ethernet oam remote-loopback
test <port> [<number-of-packets>
[<packet-size>]]
interface port-channel <port-
list>
ethernet oam
no ethernet oam
ethernet oam mode
<active|passive>
ethernet oam remote-loopback
ignore-rx
ethernet oam remote-loopback
supported
no ethernet oam remote-
loopback ignore-rx
no ethernet oam remote-
loopback supported
no ethernet oam mode
20.3 Command Examples
This example enables Ethernet OAM on port 7 and sets the mode to active.
sysname# configure
sysname(config)# ethernet oam
sysname(config)# interface port-channel 7
sysname(config-interface)# ethernet oam
sysname(config-interface)# ethernet oam mode active
sysname(config-interface)# exit
sysname(config)# exit
90
DESCRIPTION
Performs a remote-loopback test from the specified port. You
can also define the allowable packet number and packet size
of the loopback test frames.
Enters config-interface mode for the specified port(s).
Enables Ethernet OAM on the port(s).
Disables Ethernet OAM on the port(s).
Specifies the OAM mode on the ports.
active: Allows the port to issue and respond to Ethernet
OAM commands.
passive: Allows the port to respond to Ethernet OAM
commands.
Sets the Switch to ignore loopback commands received on
the ports.
Enables the remote loopback feature on the ports.
Sets the Switch to process loopback commands received on
the ports.
Disables the remote loopback feature on the ports.
Resets the OAM mode to the default value.
Ethernet Switch CLI Reference Guide
M P
E 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13