ZyXEL Communications Ethernet Switch Cli Reference Manual page 160

Chapter 33 IPv6 Commands
access the Switch. So its Ethernet interface identifier is %4 and will be used later to
make a ping.
C:\>ipconfig
Windows IP Configuration
Ethernet adapter Local Area Connection:
2 Check the Switch IPv6 address(es) you want to ping. In this example, there are two IPv6
addresses in VLAN 1. One is a link-local address (fe80::219:cbff:fe00:1/64) and the
other one is a global address (2001::1234/64).
sysname# show ipv6
VLAN ID
IPv6 Status : Enable
Origin
--------- ------------------------------------------- ---------- -------
manual
manual
3 In order to access the Switch through its link-local address, do the address convertion
(See
3a Use a dash "-" to replace each colon ":" in an IPv6 address. Then the address
3b In the step 1, the Ethernet interface identifier you want to use to connect to the
3c Append ".ipv6-literal.net" at the end. The address becomes:
160
Connection-specific DNS Suffix
IP Address. . . . . . . . . . . . : 10.1.1.46
Subnet Mask . . . . . . . . . . . : 255.255.255.0
IP Address. . . . . . . . . . . . : fe80::2d0:59ff:feb8:103c%4
Default Gateway . . . . . . . . . : 10.1.1.254
: 1
IP Address/PrefixLength
fe80::219:cbff:fe00:1/64
2001::1234/64
Table 94 on page 159).
becomes:
fe80--219-cbff-fe00-1
Switch is "%4". Replace the percentage character "%" with "s" and then append it to
the address. The address becomes:
fe80--219-cbff-fe00-1s4
fe80--219-cbff-fe00-1s4.ipv6-literal.net
. :
Status
preferred
preferred
Ethernet Switch CLI Reference Guide
Expire
permanent
permanent