ZyXEL Communications Ethernet Switch Cli Reference Manual page 84

Chapter 18 DVMRP Commands
Table 50 Command Summary: DVMRP (continued)
COMMAND
ip dvmrp
no ip dvmrp
18.3 Command Examples
In this example, the Switch is configured to exchange DVMRP information with other
DVMRP enabled routers as shown next. The Switch is a DVMRP router (C). DVMRP is
activated on IP routing domains 10.10.10.1/24 and 172.16.1.1/24 so that it can exchange
DVMRP information with routers A and B.
Figure 6 DVMRP Network Example
10.10.10.254
• Enables IGMP and DVMRP on the Switch.
• Enables DVMRP on the following routing domains: 10.10.10.1/24, 172.16.1.1/24.
• Displays DVMRP settings configured on the Switch.
sysname(config)# router igmp
sysname(config-igmp)# exit
sysname(config)# router dvmrp
sysname(config-dvmrp)# exit
sysname(config)# interface route-domain 10.10.10.1/24
sysname(config-if)# ip dvmrp
sysname(config-if)# exit
sysname(config)# interface route-domain 172.16.1.1/24
sysname(config-if)# ip dvmrp
sysname(config-if)# exit
sysname(config)# exit
sysname# show router dvmrp
TTL threshold: 50
IP Address
----------------------------------------
10.10.10.1
172.16.1.1
192.168.1.1
84
B
A
172.16.1.254
C D
Subnet Mask Active
255.255.255.0 Yes
255.255.255.0 Yes
255.255.255.0 No
DESCRIPTION
Activates this routing domain in
participating in DVMRP.
Disables this routing domain from
participating in DVMRP.
E
Ethernet Switch CLI Reference Guide
M P
C 13
C 13