ZyXEL Communications Ethernet Switch Cli Reference Manual page 206

Chapter 49 OSPF Commands
Table 118 OSPF Command Summary (continued)
COMMAND
ip ospf authentication-same-as-area
no ip ospf authentication-same-aa
no ip ospf authentication-same-as-area
ip ospf cost <1-65535>
no ip ospf cost <1-65535>
ip ospf message-digest-key <key>
no ip ospf message-digest-key <key>
ip ospf priority <0-255>
no ip ospf priority <0-255>
router ospf <router-id>
area <area-id>
no area <area-id>
area <area-id> authentication
area <area-id> authentication message-
digest
no area <area-id> authentication
area <area-iD> default-cost <0-16777214>
no area <area-id> default-cost
area <area-id> name <name>
area <area-id> stub
no area <area-id> stub
area <area-id> stub no-summary
no area <area-id> stub no-summary
area <area-id> virtual-link <router-id>
no area <area-id> virtual-link <router-
id>
area <area-id> virtual-link <router-id>
authentication-key <key>
206
DESCRIPTION
Sets the same OSPF authentication
settings in the routing domain as the
associated area.
Sets the routing domain not to use the
same OSPF authentication settings as the
area.
Sets the routing domain not to use the
same OSPF authentication settings as the
area.
Sets the OSPF cost in this routing domain.
Resets the OSPF cost in the routing
domain to default.
Sets the OSPF authentication key in this
routing domain.
Disables the routing domain from using a
security key in OSPF.
Sets the OSPF priority for the interface.
Setting this value to 0 means that this
router will not participate in router elections.
Resets the OSPF priority for the interface.
Enables and enters the OSPF
configuration mode.
Enables and sets the area ID.
Removes the specified area.
Enables simple authentication for the area.
Enables MD5 authentication for the area.
Sets the area to use no authentication
(None).
Sets the cost to the area.
Sets the area to use the default cost (15).
Sets a descriptive name for the area for
identification purposes.
Enables and sets the area as a stub area.
Disables stub network settings in the area.
Sets the stub area not to send any LSA
(Link State Advertisement).
Sets the area to send LSAs (Link State
Advertisements).
Sets the virtual link ID information for the
area.
Deletes the virtual link from the area.
Enables simple authentication and sets the
authentication key for the specified virtual
link in the area.
Ethernet Switch CLI Reference Guide
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13