ZyXEL Communications Ethernet Switch Cli Reference Manual page 64

Chapter 12 Cluster Commands
12.2 Command Examples
This example creates the cluster CManage in VLAN 1. Then, it looks at the current list of
candidates for membership in this cluster and adds two switches to cluster.
sysname# configure
sysname(config)# cluster 1
sysname(config)# cluster name CManage
sysname(config)# exit
sysname# show cluster candidates
Clustering Candidates:
Index Candidates(MAC/HostName/Model)
0 00:13:49:00:00:01/ES-2108PWR/ES-2108PWR
1 00:13:49:00:00:02/GS-3012/GS-3012
2 00:19:cb:00:00:02/ES-3124/ES-3124
sysname# configure
sysname(config)# cluster member 00:13:49:00:00:01 password 1234
sysname(config)# cluster member 00:13:49:00:00:02 password 1234
sysname(config)# exit
sysname# show cluster member
Clustering member status:
Index MACAddr
1 00:13:49:00:00:01 ES-2108PWR
2 00:13:49:00:00:02 GS-3012
The following table describes the labels in this screen.
Table 36 show cluster member
LABEL
Index
MACAddr
Name
Status
64
Name
DESCRIPTION
This field displays an entry number for each member.
This field displays the member's MAC address.
This field displays the member's system name.
This field displays the current status of the member in the cluster.
Online: The member is accessible.
Error: The member is connected but not accessible. For example, the
member's password has changed, or the member was set as the manager
and so left the member list. This status also appears while the Switch
finishes adding a new member to the cluster.
Offline: The member is disconnected. It takes approximately 1.5 minutes
after the link goes down for this status to appear.
Status
Online
Online
Ethernet Switch CLI Reference Guide