Replacement Note - Xerox Phaser 8400 Service Manual

4.
Remove the left plastic clip from the wiper belt and slide the wiper off of the belt.
Note
For the early model Phaser 8500/8550 printer, insert a small flatblade
screwdriver between the backside of the left wiper clip and the flat side of
the belt (see lower inset of the previous illustration). Applying a small
amount of pressure against the plastic wiper clip with the screwdriver, you
can gently slide the wiper off the belts.

Replacement Note:

1. Position the wiper so both ends are all the way down following reassembly (see
"Wiper Alignment Procedure" on page 6-2).
2. When reinstalling the belt into the wiper clip in the Phaser 8500/8550 printer,
place the belt partly on the clip, and then press the center of the clip with a small
needle-nose plier until the belt is secured in the clip.
Later versions of Phaser 8500/8550 serial numbered WYN1xxxxx or WYP1xxxxx
use the wider style wiper drive belt and wiper of the Phaser 8400. Refer to the Service
Bulletin 701 for more information.
Service Parts Disassembly
Wiper Belt
Wiper Clip
s8500-082
8-21