Xerox Phaser 8400 Service Manual page 133

Jam Code Troubleshooting Procedures
T2A The exit door open flag unexpectedly tripped while the printer was performing an
abnormal shutdown.
T2B The exit door open flag unexpectedly tripped while the printer was performing a
normal shutdown.
T2C The exit door open flag unexpectedly tripped while the printer was performing a
mechanical recovery.
T2D The exit door open flag unexpectedly tripped while the printer was warming up.
T2E The exit door open flag unexpectedly tripped while the printer was ready.
T2F The exit door open flag unexpectedly tripped while the printer was in a fault state.
T2G The exit door open flag unexpectedly tripped while the printer was performing an
automatic drum maintenance cycle.
T2H The exit door open flag unexpectedly tripped while the printer was performing a
printhead maintenance cycle.
T2J The exit door open flag unexpectedly tripped while the printer was performing a
printhead purge cycle.
T2K The exit door open flag unexpectedly tripped while the printer was performing a
transfix oiling cycle.
T2L The exit door open flag unexpectedly tripped while the printer was in Standby
mode.
T2M The exit door open flag unexpectedly tripped when the printer picked from Tray 2.
T2N The exit door open flag unexpectedly tripped when the printer picked from Tray 3.
T2P The exit door open flag unexpectedly tripped when the printer picked from Tray 4.
T2Q The exit door open flag unexpectedly tripped when the printer picked from Tray 1.
T2R The exit door open flag unexpectedly tripped while the printer was duplexing.
T2S The exit door open flag unexpectedly tripped while the paper was staging for the
transfix cycle.
T2T The exit door open flag unexpectedly tripped while the print was being transfixed.
T2X The exit door open flag unexpectedly tripped while the printer was ejecting the print.
Service Manual
(Continued)
3-67