Xerox Phaser 8400 Service Manual page 147

Menu Map (Continued)
Menu
Exercise Menu
A submenu containing a set of functions for actively causing mechanical actions which
may then be observed.
General Troubleshooting
Control Panel
Buttons
Activators Menu
Exercise All
Tray 1 Pick
Solenoid
Tray 2 Pick
Clutch
Tray 3 Pick
Clutch
Tray 4 Pick
Clutch
Deskew Clutch
Pre-heater
Solenoid (8500/
8550)
Strip Solenoid
Tilt Solenoid
(8500/8550)
Head
Maintenance
Clutch
Description
Monitors Control Panel buttons and
reports button presses.
Pulses the specified activator to cause
it to generate some sound or motion.
Cycles each of the listed activators 4
times in sequence until interrupted by a
Control Panel button press.
Cycles the activator repeatedly until
interrupted by a Control Panel button
press.
Cycles the activator repeatedly until
interrupted by a Control Panel button
press.
Cycles the activator repeatedly until
interrupted by a Control Panel button
press. If not installed generates an
"Option not detected" message.
Cycles the activator repeatedly until
interrupted by a Control Panel button
press. If not installed generates an
"Option not detected" message.
Cycles the activator repeatedly until
interrupted by a Control Panel button
press.
Cycles the preheater solenoid until
interrupted by pressing the Control
Panel button.
Cycles the activator repeatedly until
interrupted by pressing the Control
Panel button.
Cycles the tilt solenoid until interrupted
by pressing the Control Panel button.
Cycles the activator repeatedly until
interrupted by a Control Panel button
press.
4-7