Xerox Phaser 8400 Service Manual page 138

Jam Code Troubleshooting Procedures
Z2C Tray 4 Pick flag triggered unexpectedly during mechanical recovery.
Z2D Tray 4 pick flag triggered unexpectedly during warm-up.
Z2E Tray 4 pick flag triggered unexpectedly while printer ready.
Z2F Tray 4 pick flag triggered unexpectedly while printer in fault state.
Z2L Tray 4 pick flag triggered unexpectedly while printer in standby.
Z2M Tray 4 pick flag triggered unexpectedly while pick from Tray 2.
Z2N Tray 4 pick flag triggered unexpectedly while pick from Tray 4.
Z2P Tray 4 pick flag triggered unexpectedly while pick from Tray 4.
Z2Q Tray 4 pick flag triggered unexpectedly while pick from Tray 1.
Z2R Tray 4 pick flag triggered unexpectedly while duplexing.
Z2S Tray 4 pick flag triggered unexpectedly while paper staged for print.
Z2T Tray 4 pick flag triggered unexpectedly while transfixing the print.
Z2V Tray 4 pick flag triggered unexpectedly while the printer drum maintenance cycle
was being performed.
Z2W Tray 4 pick flag triggered unexpectedly during printer imaging.
Z2Z Tray 4 pick flag triggered unexpectedly while exiting print.
1. Ensure ground integrity of the printer, see page 4-77.
2. Run the Monitor Sensors test to test the media size sensor.
3. Replace the 525-Sheet Feeder.
4. Replace the pivot arm.
Z3B Tray 4 pick flag sensor timed out during normal shutdown.
Z3D Tray 4 pick flag sensor timed out during warm-up.
Z3E Tray 4 pick flag sensor timed out during wile printer ready.
Z3F Tray 4 pick flag sensor timed out while printer in fault state.
Z3L Tray 4 pick flag sensor timed out while printer in standby.
Z3M Tray 4 pick flag sensor timed out while pick from Tray 2.
Z3N Tray 4 pick flag sensor timed out while pick from Tray 4.
Z3P Tray 4 pick flag sensor timed out while pick from Tray 4.
Z3Q Tray 4 pick flag sensor timed out while pick from Tray 1.
Z3R Tray 4 pick flag sensor timed out while duplexing.
3-72
(Continued)
Phaser 8400/8500/8550 Color Printer