Transfix Load Module - Xerox Phaser 8400 Service Manual

Transfix Load Module

(PL 3.9)
Videos are available with instructions for replacing the Transfix Load
Module assembly. Videos are located on the Phaser 8400/8500/8550
Product Training CD-ROM. Select Service, and then select Transfix
Load Module Procedures.
1. Remove the Front Door (MPT) assembly (see page 8-4).
2. Remove the Ink Loader Assembly and Door (see page 8-8).
3.
Remove the Paper Preheater (see page 8-23).
Note
You don't need to remove the preheater if the transfix ground springs are put
on after the load module is installed.
4. Remove the Media Drive Gearbox (see page 8-48).
Note
Step 4 is not required if you are only removing the Duplex Roller.
5. Remove four screws, disconnect two connectors, and remove the Exit Module
(see page 8-40).
6.
Remove the upper and lower duplex guides (see page 8-41).
7.
Remove the Duplex Roller by removing the left KL-clip on the shaft and sliding
the left side bearing down the shaft toward the right (1) (see preceding figure).
Then slide the shaft toward the left (2) to free the right end of the shaft. Finally,
pull the shaft out towards the right side of the printer (3).
8-26 Phaser 8400/8500/8550 Color Printer