Xerox Phaser 8400 Service Manual page 150

Menu Map (Continued)
Menu
Exercise Heaters
Menu
Control Panel
Display
Function Menu
4-10
Tray 4 Motor &
Shafts
Monitor heaters
Monitor
Temperatures
All Heaters On
All Heaters Off
Toggle Printhead
Heaters
Toggle Preheat
Heater
Toggle Drum
Heater
Toggle Ink Melt
Heaters
Cycle LED
Set display dark
Test backlight
Set display light
Initialize Mechanism
Phaser 8400/8500/8550 Color Printer
Description
Cycles the motor/shaft repeatedly until
interrupted by a Control Panel button
press. If not installed generates an
"Option not detected" message.
Allows the heaters to forced to an ON
or OFF condition or to be toggled from
one condition to the other. Also,
provide monitoring to observe the
resulting heater power or temperature.
Monitors heater power.
Monitors heater temperature.
Turns all heaters On.
Turns all heaters Off
Toggles printhead heaters to opposite
state.
Toggles preheat heater to opposite
state.
Toggles drum heater to opposite state.
Toggles ink melt heaters to opposite
state. There is a melt heater for each of
the four colors.
Exercises the Control Panel LCD/LED
outputs.
Cycles the LED through a red/Yellow/
Green sequence.
Sets the LCD display dark.
Changes the display backlight from off
to max.
Sets the LCD display light.
A submenu containing a set of
functions for commanding more
complex actions by portions of the
printer mechanism.
Performs a simplified version of the
power up mechanical initialization
sequence.