Xerox Phaser 8400 Service Manual page 134

Jam Code Troubleshooting Procedures
T2Z The exit door open flag unexpectedly tripped while the printer was shutting down.
1. Ensure the media is supported.
2. Ensure ground integrity of the printer, see page 4-77.
3. Run the Monitor Sensors test.
4. Inspect the door switch for damage and proper operation.
5. Check the drum maintenance unit to ensure it is functioning properly and the
blade is not covered with ink debris.
6. Replace the drum maintenance unit.
7. Replace the transfix roller.
V2D Tray 2 media size sensor unexpectedly activated during warm-up.
V2E Tray 2 media size sensor unexpectedly activated during printer ready.
V2F Tray 2 media size sensor unexpectedly activated while printer was in a fault state.
V2K Tray 2 media size sensor unexpected event during oil transfix.
V2L Tray 2 media size sensor unexpectedly activated while the printer was in standby.
V2M Tray 2 media size sensor unexpectedly activated while picking from Tray 2.
V2N Tray 2 media size sensor unexpectedly activated while picking from Tray 3.
V2P Tray 2 media size sensor unexpectedly activated while picking from Tray 4.
V2Q Tray 2 media size sensor unexpectedly activated while picking from Tray 1.
V2R Tray 2 media size sensor unexpectedly activated while duplexing.
V2S Tray 2 media size sensor unexpectedly activated while paper staged for print.
V2T Tray 2 media size sensor unexpectedly activated while transfixing the print.
V2V Tray 2 media size sensor unexpectedly activated while print drum maintenance
cycle was being performed.
V2W Tray 2 media size sensor unexpectedly activated during printer imaging.
V2X Tray 2 media size sensor unexpectedly activated while exiting print.
1. Ensure ground integrity of the printer, see page 4-77.
2. Ensure the Tray 2 paper guides are correctly set.
3. Run the Monitor Sensors test to test the media size sensor.
4. Replace the media size sensor board.
5. Replace the pivot arm.
W2D Tray 3 media size sensor unexpectedly activated during warm-up.
W2E Tray 3 media size sensor unexpectedly activated during printer ready.
W2F Tray 3 media size sensor unexpectedly activated while printer in fault state.
3-68
(Continued)
Phaser 8400/8500/8550 Color Printer