Oki OKIPAGE 24DX Service Manual page 197

83 I/F timeout occurred between the printer
and the Duplex Unit.
84 Printing sequence error in the Duplex unit.
90 A watchdog timer timeout occurred.
F0 Monitor error (double weight)
F1 Monitor error (argument error)
F2 Optional timeout error
F3 Optional status error
F4 BG program error
F5 System timer program error
F6 IPT2 program error
F7 IPT1 program error
Category: Processor error
LCD message: ERROR CONTROLLER nn-aaaaaaaa
READY LED: Light off
ATTENTION LED: Flash
Trouble or status
An error occurred in the controller.
n = (*1) Exception Code
aaaaaaaa = Error address
1*:
Exception
code
1-3 Reserved
D-F
4 Address Error Exception
5 Address Error Exception (Store
instruction)
6 Bus Error Exception (Instruction Fetch)
7 Bus Error Exception (Load instruction,
store instruction)
- Turn the power off, then on.
- Replace the Main board (*BOARD-FFF).
Note: When replacing the Main Board, install the
EEPROM mounted on the replaced Main Board.
see #90 above
see #90 above
see #90 above
see #90 above
see #90 above
see #90 above
see #90 above
see #90 above
Error
Remedy
- Turn the power off, then on.
- Replace the Main board. BOARD-FFF)
Note: When replacing the Main Board, install
the EEPROM mounted on the replaced Main
board.
see above
see above
see above
see above