Oki OKIPAGE 24DX Service Manual page 193

Indicates that the capacity of
memory is Overflowed due to
the following reasons. The
operation is continued by
pressing Recover switch.
Additional RAM should be
installed or the amount of data
be reduced.
- Too large printing data within
one page.
- Too large macro data.
- Too large DLL data.
- Overflow after the compression
of frame buffer.
Informs that the data within the
receiving buffer Overflows. The
operation is continued by
pressing Recover switch. The
host side should be changed in
settings to be able to recognize
a printer Busy status and the
data be re-transmitted.
Informs that the printer occurs
an Overrun. The operation is
continued by pressing Recover
switch. The page formatting
should be slightly simplified. It
can be canceled in PS mode
when the job is completed.
Informs that an error occurs in
serial I/F. The operation is
continued by pressing Recover
switch. This is indicated when
parity error, framing error,
overrun error and so on is
detected. The protocol of host
and printer should be rechecked.
Informs that an error occurs in
the home position of front tray.
Although the front tray becomes
unavailable by pressing Recover
switch, the other trays continue
operating normally.
Promotes by indication that a
cartridge should be replaced
after a 100-sheet printing since
the detection of toner low. It is
temporarily reset by opening and
closing the cover. This indication
will be displayed each 20-sheet
printing unless the cartridge is
replaced.
Press the RECOVER key on the
operator panel to release the
error display. Install an
expansion optional RAM or
reduce the amount of print data.
Press the RECOVER Key on the
operator panel to release the
error display. Change the setting
of the host side so that the host
can detect the busy state of the
printer. Resend the data from
the host side to the printer.
Press the RECOVER key on the
operator panel to release the
error display. Simplify page data
formatting.
- Press the RECOVER key on
the operator panel to release the
error display.
- Check the settings of RS232C
I/F in the menu.
- Replace the interface cable or
the Main board (Board - FFF).
Note: When replacing the Main
board, install the EEPROM
mounted in the replaced Main
board.
Check front tray home sensor.
Replace the toner cartridge.